![]() ![]() ![]() This matter had been discussed a lot of times in this forum also. There are a lot of documents how a project should be created under Ecliplse + Yagart + OpenOCD. The code you are trying to use is custom. Warning: cannot set software breakpoint at readonly address 0x804aefcĪs far as I see the board and the debugger connect fine. Target halted due to breakpoint, current mode: Threadġ breakpoint del y 0x0804aefc in main() at. Requesting target halt and executing a soft reset Monitor flash write_image "C:/vr-universal-ide/workspaces/UF4_AP/vrbrain/Acopter32-STM32F4/build/laserlab_MP32V1F4.elf" 0 elfĮrror executing stm32x flash write algorithmĮrror writing to flash at address 0x08000000 at offset 0x00000000 Polling target stm32f4x.cpu succeeded againĬleared protection for sectors 0 through 11 on flash bank 0 Polling target stm32f4x.cpu failed, GDB will be halted. Target halted due to debug-request, current mode: Thread Stm32f4x.cpu - clearing lockup after double fault
0 Comments
Leave a Reply. |